Sear spring tool CZ75 Eemann ET-130067

Eemann Tech sear spring installation tool for CZ 75 pistols and their clones. Either for general maintenance or because your spring broke, on the range or in your workshop, this tool will simplify a normally very tricky job and substantially reduce the time it usually takes. You can replace or install your sear spring in seconds without any experience. 

The new Eemann Tech sear spring tool incorporates a tiny neodeum magnet which holds the sear spring very securely whilst the short leg of the sear spring rests in a micro hole within the tool. There are special relief cuts in the tool that allow it to be positioned correctly for the instal. The tool is made of brass that is softer than the spring thus will not damage it, but it's hard enough to perform the task.

Compatible with all CZ 75 type pistols and their clones:

• CZ 75 pistols

• CZ Shadow 2 pistols

• Tanfoglio pistols

Material: Brass